Monday 18 September 2017

More Thicknesser Development

It's almost finished now, here's a pic with the power plane missing, but it's sole plate is screwed to the top to give alignment as it is all built up.
I've put feet across the bottom spaced so that can be clamped on to the workmate. The adjust wheel is more central now, slightly less convenient, but better mechanically, the screw that pushes upwards bears against a bit of steel plate. I've made lots of improvements to take out slop. The biggest factor is probably the thickness of the table which rides up and down smoothly with no real room to twist.
The only problem is I don't know where I'll have room to store it, maybe I need another major sort out.
Most of the wood is off-cuts from shelving that I've been doing and bits that were hanging around.
Just added a pic with it all finished and set up with a length of Purpleheart in there for tapering.

Update:- It works a treat, no perceptible ripple, bit noisy of course and you have to take the cut in stages, con't just rip a great big taper off in one go. An advantage over a sander style thicknesser is it produces chippings rather than dust. The chips are much easier to collect/sweep up. It does throw 'em out of the front with some force so you can feel 'em pinging onto the back of your hand.

1 comment:

  1. Looks much more robust & accurate, and I like that fact that you can clamp it down - nice!

    ReplyDelete