Saturday 25 February 2012

Miniature Horn Nock

I found that the best way to do it was exactly the same as I'd make a full sized one. I had to re-grind the tip of one of my tools to get the finer taper and I even made a small version of the fitting tool to sand down the end for a good fit.
It's not 100% finished yet, but you can see it's coming on rather nicely.

I realised, I'm still about an inch short of the target draw length, because the rule on the tiller is adjusted to measure from the back of the last bow I did which was over an inch thick.

1 comment:

  1. That is a very nice piece of work, sir.
    Emmett

    ReplyDelete